Avery 9855 Instruction Manual download pdf (Page 36)

4-8 Operator’s Handbook

Positioning

This menu includes selections to change the print, supply, margin, cut, and

dispense positions along with the backfeed distance.

When you see

Enter print pos

[-450/450]: +0

Feed/Cut acts as a toggle switch to change the value by 10 or 1. For

example, to make the print position 23 (from the default of 0), press

Feed/Cut, then press » twice (20), press Feed/Cut again and press ¼ three

times (23).

Print Position

This function adjusts where data prints vertically on the supply. Adjust the

print if it is too close to the top or bottom of the supply, or overtypes the pre-

printed area. One dot is 0.0049 inch.

For RFID supplies with a one-inch feed length, adjust the print position

and/or the supply position as shown in the RFID Setup Guide & Supply Chart

or the HF Setup Guide & Supply Chart.

♦ If the data is too close to the bottom, increase the number.

♦ If the data is too close to the top, decrease the number.

Note: Changing this setting only affects new formats sent to the printer.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 119 120

No comments

Avery 9855 Instruction Manual Page 36